1. Introducció
This manual provides essential information for the safe and efficient installation, operation, and maintenance of your Grundfos UP15-29SU/LC 59896776 circulator pump. The UP15-29SU/LC is a canned rotor pump designed for hot water circulation systems, featuring a maximum power input of 87W and durable stainless steel construction. It operates as an integral unit without a shaft seal, utilizing only two gaskets for sealing, and its bearings are lubricated by the pumped liquid.
Key characteristics include ceramic shaft and radial bearings, a carbon axial bearing, a stainless steel rotor can and bearing plate, and a corrosion-resistant composite (PES) impeller. The pump housing is made of stainless steel. The motor is a 1-phase type, requiring no additional motor protection.
This image shows the Grundfos UP15-29SU/LC 59896776 circulator pump, a compact unit with a red motor housing and stainless steel pump body, designed for hot water circulation systems.
2. Configuració i instal·lació
2.1 Precaucions de seguretat
- Assegureu-vos que el subministrament elèctric estigui desconnectat abans de qualsevol treball d'instal·lació o manteniment.
- Utilitzeu equips de protecció personal adequats.
- Installation should be performed by a qualified professional in accordance with local codes and regulations.
2.2 Directrius d'instal·lació
- The pump is designed for a 1-1/4" NPSM pipe connection with S.S. Union type connections. The port-to-port length is 5.87 inches.
- The maximum operating pressure is 145 psi.
- The maximum ambient temperature for operation is 104 °F (40 °C). When the liquid temperature is 176 °F (80 °C), the maximum ambient temperature is also 176 °F (80 °C).
- Important: For optimal performance and to prevent noise, the pump should be installed with the circular motor part oriented horizontally (laying on its side), not straight up. Refer to the manufacturer's detailed installation diagrams for correct orientation.
- Ensure all connections are secure and leak-free. It is recommended to use new washers during installation, as they may not be included with the pump.
- Avoid damaging the internal bushings during installation.
2.3 Connexió elèctrica
- The pump operates on 1 x 115 V, 60 Hz power supply.
- It has a 3-prong plug. Ensure a properly grounded 3-prong (two plus ground) receptacle is available or installed.
- The pump can be wired to a thermostatic controller for automated operation.
3. Instruccions de funcionament
3.1 Posada en marxa inicial
- After installation, ensure the system is filled with water and properly vented to remove any air.
- Restableix l'alimentació a la bomba.
- The pump should start circulating water, often with a quiet hum.
3.2 Funcionament normal
- The pump is designed for continuous hot water circulation, providing instant hot water at fixtures.
- The liquid temperature range for operation is 35.6 °F to 230 °F (2 °C to 110 °C).
- When connected to a thermostatic controller, the pump will operate according to the set temperature parameters, optimizing energy usage.
- The pump is known for its quiet operation. Any unusual noise should be investigated.
4. Manteniment
The Grundfos UP15-29SU/LC pump is designed for minimal maintenance due to its canned rotor design and liquid-lubricated bearings. However, periodic checks are recommended to ensure optimal performance and longevity.
- Inspecció visual: Regularly inspect the pump and connections for any signs of leaks, corrosion, or damage.
- Control de soroll: Listen for any unusual noises during operation. A sudden increase in noise could indicate an issue.
- Neteja del sistema: If the water quality is poor, periodic flushing of the system may be beneficial to prevent buildup within the pump.
- Bushing Protection: When handling or reinstalling the pump, take care not to damage the internal bushings.
5. Solució De Problemes
If you encounter issues with your Grundfos circulator pump, consider the following common troubleshooting steps:
| Problema | Causa possible | Solució |
|---|---|---|
| Pump not running / No hot water circulation | No power, tripped breaker, faulty wiring, seized impeller. | Check power supply and circuit breaker. Verify electrical connections. Consult a professional if impeller is suspected to be seized. |
| Soroll excessiu durant el funcionament | Air in the system, incorrect installation orientation, worn bearings, debris in pump. | Vent the system to remove air. Verify pump orientation (circular motor part should be horizontal). Check for debris. If noise persists, professional inspection may be needed. |
| Leaking from pump or connections | Loose connections, damaged gaskets/washers, crack in housing. | Tighten connections. Replace old or damaged gaskets/washers. If housing is cracked, pump replacement is necessary. |
| Inconsistent hot water | Thermostatic controller malfunction, partial blockage, pump cycling incorrectly. | Check thermostatic controller settings and function. Inspect system for blockages. |
If these steps do not resolve the issue, contact Grundfos customer support or a qualified plumbing professional.
6. Especificacions
| Característica | Detall |
|---|---|
| Número de model | UP15-29SU/LC 59896776 |
| Fabricant | Grundfos |
| Tipus | Canned Rotor Circulator Pump |
| Material (Pump Housing) | Stainless Steel (DIN W.-Nr. 1.4301, AISI 304) |
| Material (Impeller) | Composite, PES |
| Font d'alimentació | Elèctric amb cable |
| Voltage | 1 x 115 V |
| Freqüència principal | 60 Hz |
| Màx. Entrada de potència | 87 W |
| Rated Power - P2 | 0.121 CV |
| Current in Speed 3 | 0.75 A |
| Capacitor Size - Run | 10 µF/180 V |
| Insulation Class (IEC 85) | F |
| Pressió màxima de funcionament | 145 psi |
| Rang de temperatura del líquid | 35.6 .. 230 °F (2 .. 110 °C) |
| Temperatura ambiental màxima | 104 °F (40 °C) |
| Connexió de canonades | 1 1/4" NPSM |
| Tipus de connexió | S.S. Union |
| Port-to-Port Length | 5.87 polzades |
| Pes de l'article | 5.19 lliures |
| Dimensions del producte | 0.08 x 6 x 7 polzades |
| Aprovacions | UL, CSA |
7. Informació de la garantia
Specific warranty details for the Grundfos UP15-29SU/LC 59896776 circulator pump are typically provided with the product packaging or available on the official Grundfos website. Please refer to the documentation included with your purchase or visit us.grundfos.com for the most current warranty terms and conditions.
8. Suport i contacte
For technical assistance, spare parts, or further inquiries regarding your Grundfos circulator pump, please contact Grundfos customer support or visit their official weblloc.
- Oficial Weblloc: us.grundfos.com
- Refer to the Grundfos weblloc web per obtenir números de contacte i ubicacions de centres de servei a la vostra regió.