LASCO 24V Heat Only Thermostat

White Rodgers 24V Heat Only Thermostat Instruction Manual

Model: 24V Heat Only Thermostat

1. Introducció

This manual provides comprehensive instructions for the installation, operation, and maintenance of your White Rodgers 24V Heat Only Thermostat. This device is designed to control heating systems by maintaining a desired temperature within a range of 50 to 90 degrees Fahrenheit (10 to 32 degrees Celsius). Please read these instructions carefully before proceeding with installation or operation to ensure safe and efficient use.

2. Informació de seguretat

Observeu sempre les precaucions de seguretat següents:

  • Risc elèctric: Disconnect power to the heating system at the main fuse or circuit breaker panel before installing or servicing the thermostat. Failure to do so may result in electrical shock or equipment damage.
  • Voltage Compatibilitat: This thermostat is designed for 24V heating systems only. Do not use it with line voltage (120V or 240V) systems.
  • Instal·lació professional: If you are unfamiliar with electrical wiring, it is recommended to have a qualified electrician or HVAC technician install this thermostat.
  • Eliminació adequada: Dispose of old thermostats and packaging materials according to local regulations.

3. Instal·lació i configuració

Seguiu aquests passos per a una instal·lació correcta:

3.1 Ubicació de muntatge

Install the thermostat on an inside wall, approximately 5 feet (1.5 meters) above the floor. Avoid locations:

  • Near windows, outside doors, or vents.
  • Near heat-generating appliances (e.g., televisions, lamps, refrigerators).
  • In direct sunlight or areas with poor air circulation.

3.2 Cablejat

Before wiring, ensure power to the heating system is OFF.

  1. Remove the cover of the old thermostat and note the wire connections. Typically, a heat-only system will have two wires: 'R' (power) and 'W' (heat call).
  2. Disconnect the wires from the old thermostat.
  3. Mount the new White Rodgers thermostat base to the wall using the provided screws.
  4. Connect the 'R' wire to the 'R' terminal and the 'W' wire to the 'W' terminal on the new thermostat. Ensure connections are secure.
  5. Substituïu la coberta del termòstat.

3.3 Engegada inicial

Restore power to the heating system at the main fuse or circuit breaker panel. The thermostat is now ready for operation.

White Rodgers Heat Only Thermostat with temperature dial and OFF/ON switch

Figura 1: Davant view of the White Rodgers Heat Only Thermostat. The upper slider controls the OFF/ON function, while the lower slider sets the desired temperature, indicated in both Fahrenheit (50-90) and Celsius (10-32).

4. Instruccions de funcionament

The White Rodgers Heat Only Thermostat features simple manual controls.

4.1 Control de potència

The upper slider on the thermostat controls the power to the heating system:

  • Feu lliscar cap a OFF: Disables the heating system.
  • Feu lliscar cap a ON: Enables the heating system to operate based on the set temperature.

4.2 Configuració de la temperatura

The lower slider on the thermostat is used to set your desired room temperature:

  1. Ensure the upper slider is set to ON.
  2. Move the lower slider to the desired temperature setting. The scale indicates temperatures in both Fahrenheit (50-90°F) and Celsius (10-32°C).
  3. The heating system will activate when the room temperature falls below your set point and will turn off when the room temperature reaches or exceeds your set point.

5. Manteniment

This thermostat requires minimal maintenance.

  • Neteja: Netegeu periòdicament l'exterior del termòstat amb un drap suau i sec.amp tela. No utilitzeu netejadors abrasius ni dissolvents.
  • Eliminació de pols: Gently remove any dust accumulation from the vents or internal components using a soft brush or compressed air. Ensure power is off before cleaning internal components.
  • This model does not require battery replacement as it is a mechanical, 24V wired thermostat.

6. Solució De Problemes

If you encounter issues with your thermostat, refer to the following table:

ProblemaCausa possibleSolució
Sense calor
  • Thermostat set to OFF.
  • La temperatura establerta és massa baixa.
  • Fusible cremat o interruptor de circuit activat.
  • Cablejat solt.
  • Heating system malfunction.
  • Set thermostat to ON.
  • Increase set temperature above room temperature.
  • Comproveu i substituïu el fusible o reinicieu l'interruptor.
  • Check wiring connections (ensure power is OFF).
  • Contact an HVAC technician.
Lectura de temperatura inexacta
  • Ubicació del termòstat afectada per corrents d'aire o fonts de calor.
  • Acumulació de pols.
  • Relocate thermostat if possible, or shield from drafts/heat sources.
  • Clean thermostat (ensure power is OFF).
Heating system runs continuously
  • El termòstat està massa alt.
  • Mal funcionament del termòstat.
  • Temperatura ajustada més baixa.
  • If problem persists, contact an HVAC technician.

7. Especificacions

  • Marca: White Rodgers (Manufactured by LASCO)
  • Model: 24V Heat Only Thermostat
  • Voltage: 24 Volts
  • Actual: 1.2 Amps
  • Interval de temperatura: De 50 a 90 °C (10 a 32 °F)
  • Tipus de visualització: Manual Slider
  • Tipus de control: Button Control (Slider)
  • Il·luminació de fons: No
  • Dimensions: Approximately 20 x 7 x 8.8 inches (Product packaging dimensions, actual unit smaller)
  • Pes de l'article: 6.4 unces
  • UPC: 786710545658

8. Garantia i Suport

Specific warranty information for this White Rodgers thermostat is not provided in the product details. For warranty claims or technical support, please refer to the contact information provided with your purchase or visit the official White Rodgers website. Keep your proof of purchase for any warranty-related inquiries.

Ask a question about this manual

Ask about setup, troubleshooting, compatibility, parts, safety, or missing instructions. Manuals+ will review the question and use this page’s manual context to help answer it.