1. Producte acabatview
The Frymaster 8030002 Filter Powder is a genuine OEM replacement part designed for use with commercial deep fryers. This product consists of 80 individual packs of filter powder, formulated to assist in the filtration process of cooking oil. Regular use of filter powder helps to remove impurities, extend the useful life of cooking oil, and maintain the quality of fried food.
Image 1.1: A collection of 80 individual packets of Frymaster filter powder. Each packet is a small, sealed white pouch, typically containing a single dose of the powder for oil filtration. The packets are designed for convenient and precise application in commercial deep fryers.
2. Informació de seguretat
- Always follow the deep fryer manufacturer's instructions for filtration and maintenance.
- Ensure the deep fryer is turned off and cooled to a safe temperature (typically below 180°F / 82°C) before beginning any filtration process. Hot oil can cause severe burns.
- Wear appropriate personal protective equipment (PPE), including heat-resistant gloves and eye protection, when handling hot oil or performing filtration.
- Avoid direct contact of the filter powder with skin and eyes. In case of contact, rinse thoroughly with water. Consult a medical professional if irritation persists.
- Do not ingest the filter powder. Keep out of reach of children and pets.
- Store filter powder in a cool, dry place, away from direct sunlight and moisture.
3. Instruccions de funcionament
This filter powder is designed to be used as part of a regular oil filtration routine for commercial deep fryers. The exact procedure may vary slightly depending on your fryer model and filtration system. Always refer to your fryer's operation manual for specific instructions.
General Filtration Steps:
- Prepare the Fryer: Ensure the fryer is turned off and the oil has cooled to a safe filtration temperature (typically between 140°F - 180°F / 60°C - 82°C). Remove any large food particles from the oil.
- Set Up Filtration System: Activate your fryer's built-in filtration system or prepare an external filtration unit according to its instructions. Ensure all filters (paper, screen, etc.) are clean and properly installed.
- Add Filter Powder: Once the oil begins to circulate through the filtration system, carefully open one individual packet of Frymaster filter powder (Model 8030002). Slowly pour the entire contents of the packet into the hot oil, preferably near the drain or intake point of the filtration system, to ensure it mixes thoroughly.
- Circulate Oil: Allow the oil to circulate through the filtration system with the added powder for the recommended duration, typically 5-10 minutes, or as specified by your fryer manufacturer. This allows the powder to absorb impurities and fine particles.
- Complete Filtration: Turn off the filtration system and allow any remaining oil to drain back into the fryer vat. Dispose of the used filter media and absorbed powder according to local regulations.
- Refill and Reheat: Once filtration is complete, refill the fryer with the filtered oil. If necessary, add fresh oil to reach the proper fill level. Reheat the oil to the desired cooking temperature.
Nota: Use one individual packet of filter powder per filtration cycle for optimal results.
4. Manteniment
Consistent use of Frymaster filter powder is a key component of a comprehensive fryer maintenance program. To maximize oil life and food quality:
- Daily Filtration: Filter your fryer oil at least once daily, or more frequently during periods of high usage.
- Desnatat: Regularly skim the surface of the oil throughout the day to remove large food particles.
- Nivell d'oli: Maintain the correct oil level in the fryer by adding fresh oil as needed.
- Boil-Out: Perform a full fryer boil-out and deep cleaning regularly, typically weekly, to remove carbon buildup and residue.
- Filter Media Replacement: Replace your fryer's filter paper or other filter media as recommended by the fryer manufacturer, usually with each filtration cycle or daily.
5. Solució De Problemes
If you encounter issues with oil clarity or filtration effectiveness after using the Frymaster filter powder, consider the following:
| Problema | Causa possible | Solució |
|---|---|---|
| Oil remains cloudy after filtration. | Insufficient circulation time; filter media is clogged or incorrect; oil is excessively degraded. | Increase circulation time; replace filter paper/media; consider replacing the oil entirely if severely degraded. |
| Filter powder not dissolving or mixing properly. | Oil temperature too low; powder added too quickly or in one clump. | Ensure oil is at recommended filtration temperature (140°F - 180°F); add powder slowly and evenly while oil is circulating. |
| Reduced oil flow during filtration. | Clogged filter media; pump issue with filtration system. | Replace filter media; consult your fryer's service manual for filtration pump troubleshooting. |
For persistent issues, contact Frymaster customer support or a qualified service technician.
6. Especificacions
- Número de peça: 8030002
- Tipus de producte: Filter Powder (Individual Packs)
- Quantitat: 80 Indiv Packs
- Marca: Frymaster
- País d'origen: Estats Units
- Dimensions del paquet: 18.1 L x 18 A x 14 A (polzades)
- Pes del paquet: 6.9 lliures
7. Garantia i Suport
As a genuine OEM replacement part, the Frymaster 8030002 Filter Powder is subject to Frymaster's standard warranty terms for parts. For specific warranty details, technical support, or service inquiries, please contact Frymaster directly or refer to their official weblloc.
For further assistance, please visit the official Frymaster weblloc o poseu-vos en contacte amb el seu departament d'atenció al client.
