Introducció
This manual provides essential information for the proper installation, operation, and maintenance of the Fiamma 98655-121 F45 Plus End Stop Device. This component is designed as a replacement part for Fiamma F45 awnings, specifically for models ranging from 2.5 to 3.5 meters in length. Please read this manual thoroughly before attempting any procedures.
Informació de seguretat
- Always wear appropriate personal protective equipment (PPE) such as gloves and eye protection during installation or maintenance.
- Ensure the awning is fully retracted and secured before beginning any work on the end stop device.
- If you are unsure about any step, consult a qualified technician or refer to the complete awning manual.
- Mantingueu les peces petites allunyades dels nens.
Contingut del paquet
The package contains one Fiamma 98655-121 F45 Plus End Stop Device. Please verify all components are present and undamaged upon opening the package.
Figura 1: The Fiamma 98655-121 F45 Plus End Stop Device. This image shows the blue plastic housing, the metal shaft, and the internal spring mechanism.
Configuració i instal·lació
This section outlines the general steps for replacing or installing the end stop device. Specific procedures may vary slightly depending on your awning model. Refer to your awning's primary instruction manual for detailed installation steps.
- Preparació: Ensure the awning is fully closed and secured. Disconnect any power supply if it's an electric awning.
- Accés: Carefully access the end of the awning where the end stop device is located. This may involve removing an end cap or cover.
- Eliminació (si s'ha de substituir): Identify how the existing end stop device is secured (e.g., screws, clips). Carefully remove it, noting its orientation.
- Instal·lació: Insert the new Fiamma 98655-121 end stop device into position. Ensure it is correctly aligned and seated.
- Segur: Fasten the new device using the appropriate hardware (not included with this part, typically reused from the original installation).
- Torneu a muntar: Replace any covers or end caps that were removed.
- Prova: Slowly extend and retract the awning a few times to ensure the new end stop device functions correctly and the awning stops at the appropriate points.
Funcionament del dispositiu
The Fiamma 98655-121 F45 Plus End Stop Device is a passive component designed to limit the extension and retraction of your Fiamma F45 awning. It works in conjunction with the awning's internal mechanisms to ensure the awning stops at its fully extended and fully retracted positions, preventing over-extension or over-retraction that could damage the awning or its components. No direct user operation is required for this specific device once installed correctly.
Manteniment
Regular inspection of the end stop device can help ensure the longevity and proper function of your awning.
- Inspecció visual: Periodically inspect the end stop device for any signs of wear, cracks, or damage.
- Neteja: If necessary, gently clean the device with a soft, damp drap per eliminar la brutícia o els residus. Eviteu utilitzar productes químics aggressivs o netejadors abrasius.
- Comprovació de la funció: During awning operation, observe that the awning consistently stops at its intended limits. If it over-extends or over-retracts, the end stop device or other awning components may require attention.
Resolució de problemes
| Problema | Causa possible | Solució |
|---|---|---|
| Awning over-extends or over-retracts. | Damaged or worn end stop device. Incorrect installation. | Inspect the end stop device for damage and replace if necessary. Verify correct installation as per the awning's manual. |
| Device does not fit. | Incorrect model purchased. | Verify the model number (98655-121) against your awning's requirements. This device is for Fiamma F45 Plus awnings 2.5-3.5M. |
Especificacions
| Atribut | Detall |
|---|---|
| Número de model | 98655-121 |
| Marca | Fiamma |
| Pes de l'article | 7.4 unces |
| Dimensions del producte | 4.96 x 2.56 x 2.13 polzades (aprox. 12.6 x 6.5 x 5.4 cm) |
| Compatibilitat | Fiamma F45 Plus Awnings (2.5-3.5M) |
| Tipus d'ascensor | Manual (refers to awning operation, not the device itself) |
Figura 2: Dimensions of the Fiamma 98655-121 End Stop Device, showing a length of approximately 4.9 inches (12 cm).
Garantia i Suport
Information regarding the specific warranty for the Fiamma 98655-121 F45 Plus End Stop Device is not provided in this document. Please refer to the original purchase documentation or contact Fiamma customer support for warranty details and technical assistance.
For further support, visit the official Fiamma weblloc o poseu-vos en contacte amb el seu departament d'atenció al client. Visit Fiamma Official Weblloc
