Introducció
The PATPET Shock Collar system is designed to assist in training dogs weighing between 10 to 120 lbs. It provides effective and humane methods to correct unwanted behaviors such as excessive barking, chewing, biting, and digging. This system offers a long control range of up to 4000 feet in open areas and is IPX7 waterproof, making it suitable for various training environments.
The collar features multiple training modes including beep, vibration, and adjustable shock levels, allowing for customized training based on your dog's needs and temperament.
Components del producte
- Transmissor remot
- Receiver Collars (2 units)
- Cable de càrrega dual
- Punts de contacte curts i llargs
- Rubber Caps for Contact Points
- Eina de prova de llum
Figura 1: Mésview of the PATPET Shock Collar system components.
Configuració
Preparing the Receiver Collar
Before placing the receiver collar on your dog, ensure the appropriate contact points are installed. For dogs with short hair, use the shorter contact points. For dogs with long or thick hair, use the longer contact points to ensure proper contact with the skin. You may also install the provided rubber caps over the contact points to reduce the intensity of the shock, if desired.
Figure 2: Installing contact points onto the receiver collar.
Figure 3: Attaching rubber caps for reduced shock intensity.
Adjusting the Collar Fit
The collar should fit snugly on your dog's neck to ensure the contact points touch the skin. You should be able to fit two fingers comfortably between the collar strap and your dog's neck. A loose collar may not deliver consistent stimulation, while a too-tight collar can cause discomfort.
Video 1: Demonstrates how to properly adjust the collar for a secure and comfortable fit on your dog.
If the collar strap is too long, you can trim the excess length with scissors after ensuring the correct fit. This prevents the dog from chewing on the excess strap.
Figure 4: Trimming excess collar strap for a better fit and to prevent chewing.
Instruccions de funcionament
Encesa/apagada
To turn on the remote transmitter, slide the ON/OFF button located on the side. The LED indicator will light up. To turn off, slide the button back to the OFF position.
For the receiver collar, press and hold the power button until the LED light illuminates. To turn off, press and hold the power button again until the LED light turns off.
Figure 5: Location of the ON/OFF button on the remote transmitter.
Canvi de canals
The remote transmitter supports training for up to two receiver collars. Use the channel switch on the side of the remote to toggle between Channel 1 and Channel 2, allowing you to control individual collars.
Video 2: Instructions on how to switch between different channels on the remote to control multiple collars.
Modes d’entrenament
The PATPET Shock Collar offers three distinct training modes:
- Mode bip: Delivers an audible tone to get your dog's attention.
- Mode de vibració: Provides a gentle vibration, useful for initial training or sensitive dogs.
- Mode de xoc: Delivers a static stimulation. This mode has adjustable intensity levels.
Figure 6: Remote control buttons for activating Beep, Vibration, and Shock modes.
Ajust de la intensitat
The shock mode features 16 adjustable intensity levels. Use the up/down buttons on the side of the remote to increase or decrease the stimulation level. Start with the lowest level and gradually increase it until your dog responds.
