Frigidaire ULTRAWF PureSource Ultra Refrigerator Water Filter Replacement Manual

Producte acabatview

The Frigidaire ULTRAWF PureSource Ultra Water Filter is designed to provide fresh, great-tasting water directly from your refrigerator. This filter reduces up to 99% of common contaminants found in tap water, including chlorine taste and odor, lead, nitrates, pesticides, and mercury. Regular replacement ensures optimal performance and water quality.

Informació important de seguretat

• Only replace with genuine Frigidaire filters to ensure proper fit and filtration performance.
• Refer to your refrigerator's owner's manual for specific instructions and safety warnings.
• Ensure the water supply to the refrigerator is turned off before replacing the filter to prevent leaks.
• After installation, flush the new filter by dispensing water for 3 minutes (approximately 1.5 gallons) to remove trapped air and carbon fines.

Instruccions d'instal·lació

1. Locate the water filter compartment inside your refrigerator. This is typically found in the upper right corner of the fresh food section.
2. Push the old filter inward to release it. It should pop out slightly.
3. Pull the old filter straight out from the compartment. Some water may drip, so have a towel ready.
4. Remove any protective caps or covers from the new filter.
5. Align the new filter with the filter housing.
6. Push the new filter firmly into the compartment until it clicks into place. Ensure it is fully seated.
7. Run water through the dispenser for approximately 3 minutes (about 1.5 gallons) to prime the filter and remove any air or carbon particles. Discard this initial water or use it for watering plants.

Operació i Manteniment

Freqüència de substitució recomanada

It is recommended to replace your Frigidaire PureSource Ultra water filter every 3 to 6 months, or after dispensing 200 gallons of water, whichever comes first. This ensures continuous reduction of contaminants and optimal water flow.

Restabliment de l'indicador lluminós del filtre

Your refrigerator's filter reminder light does not turn off automatically after replacing the filter. To reset the indicator light, press and hold the water filter button on the dispenser control panel for 3 seconds. The display should change from red to green, indicating the status has been reset.

Especificacions

Compatibilitat de models

The Frigidaire ULTRAWF PureSource Ultra water filter is compatible with various Frigidaire refrigerator models. To ensure compatibility, always check your refrigerator's manual or the filter's packaging for a list of supported models.

Benefits of Filtered Water

Reducció de contaminants

The PureSource Ultra filter uses a carbon-based filtration system to significantly improve water quality. It reduces common impurities and contaminants that can affect the taste and safety of your drinking water. These include:

• Chlorine (taste and odor)
• Heavy metals such as lead and mercury
• Compostos orgànics volàtils (COV)
• Pesticides and insecticides
• BPA

Tecnologia de filtració

Activated carbon technology is employed in the PureSource Ultra filter. This material has an enormous surface area, acting like a magnet to physically trap, remove, and filter out sediments, lead, mercury, VOCs, chemicals, pharmaceuticals, BPA, and pesticides. Chemical reactions within the filter further reduce substances like chlorine.

Impacte ambiental

Using a Frigidaire water filter is an environmentally conscious choice. By replacing bottled water with filtered water from your refrigerator, you contribute to reducing plastic waste. It is estimated that using water filters can save millions of plastic bottles from landfills, as each plastic bottle takes an estimated 450 years to biodegrade.

Recursos addicionals

For further assistance or to purchase additional filters, please visit the official Botiga Frigidaire a Amazon.