1. Introducció
This manual provides essential instructions for the safe operation, maintenance, and troubleshooting of your Dapper Supply DP-WBFS1201 Battery Powered Walk-Behind Floor and Carpet Scrubber, Buffer, and Polisher Machine. Please read this manual thoroughly before operating the machine to ensure proper use and to prevent injury or damage.

Image 1.1: The Dapper Supply DP-WBFS1201 floor scrubber shown with a hard brush, soft brush, and three scouring pads (white, red, black).
2. Informació de seguretat
Always observe the following safety precautions to reduce the risk of injury or damage to the machine:
- Llegiu totes les instruccions abans de fer funcionar la màquina.
- Ensure the machine is turned off and unplugged from the charger before performing any maintenance or adjustments.
- Do not operate the machine in hazardous environments or near flammable liquids or gases.
- Utilitzeu equips de protecció individual (EPI) adequats, com ara ulleres de seguretat i calçat antilliscant.
- Mantingueu els nens i el personal no autoritzat allunyats de la zona d'operació.
- Do not use the machine on excessively sloped surfaces.
- Only use Dapper Supply approved replacement parts and accessories.
- The machine operates on 24 Volts (2 x 12V batteries). Ensure proper battery handling and charging procedures are followed.
3. Contingut del paquet
Verifiqueu que tots els elements siguin presents al paquet:
- Dapper Supply DP-WBFS1201 Floor Scrubber Machine
- Hard Brush (Multi-surface)
- Soft Brush (For carpets)
- 3 Scouring Pads (White, Red, Black)
- 2 x 12V Lead Acid Batteries (pre-installed or included separately)
- Battery Charger (if applicable, not explicitly listed but implied for battery-powered)
- Manual d'usuari

Image 3.1: The included hard brush, soft brush, and three scouring pads (white, red, black) for various cleaning tasks.
4. Configuració
- Desembalatge: Traieu amb cura la màquina i tots els accessoris de l'embalatge. Inspeccioneu-ho per veure si hi ha danys durant l'enviament.
- Ajust del mànec: Adjust the handle to a comfortable operating height. The adjustable handle allows operators to tailor the height to their preference.

Image 4.1: Detail of the handle adjustment levers, typically yellow, located at the base of the handle column.
- Instal·lació/càrrega de la bateria: Ensure the two 12V lead-acid batteries are correctly installed and fully charged before first use. Refer to the battery charging instructions for details.

Imatge 4.2: View of the battery compartment, showing the two 12V batteries connected within the machine.
- Instal·lació del raspall/coixinet:
- Select the appropriate brush or pad for your cleaning task.
- White Pad: For light abrasive scrubbing and routine cleaning.
- Red Pad: For medium abrasive scrubbing, suitable for tougher dirt and stains.
- Black Pad: For heavy-duty tasks, stripping, sanding, and stubborn grime.
- Hard Brush: For multi-surface floor cleaning.
- Pinzell suau: Specifically designed for carpet cleaning.
- Attach the chosen brush or pad securely to the machine's brush head. Ensure it is centered and locked into place.
- Select the appropriate brush or pad for your cleaning task.
- Omplir el dipòsit de solució: Open the solution tank cap and fill with the appropriate cleaning solution and water mixture. The machine has a 6.5-gallon solution tank. Do not overfill.
5. Instruccions de funcionament
- Comprovació prèvia al funcionament:
- Verify batteries are charged.
- Ensure solution tank is filled.
- Confirm brush/pad is correctly installed.
- Check that the recovery tank is empty.
- Inici de la màquina: The machine features an intuitive 1-button start-up control. Press the power button to activate the machine.
- Engaging Cleaning:
- Baixeu el capçal del raspall al terra.
- Engage the brush motor. The brush speed is 200 RPM.
- Activate the water control valve to dispense cleaning solution. The automatic cleaning system eliminates the need for manual water flow management.
- Lower the squeegee to the floor to ensure proper water recovery. The squeegee width is 21.5 inches.

Image 5.1: The brush head in operation, highlighting the 500-Watt brush motor and the 1-button start-up control panel.
- Funcionament: Guide the machine across the floor at a steady pace. The 500-Watt high-strength suction motor ensures rapid water extraction, leaving floors dry.
- Aturar la màquina: Disengage the brush motor and water flow. Raise the brush head and squeegee. Press the power button to turn off the machine.
6. Manteniment
Regular maintenance ensures optimal performance and extends the life of your machine.
- Buidatge i neteja de dipòsits:
- After each use, empty the recovery tank (8-gallon capacity) and rinse it thoroughly with clean water.
- Drain any remaining solution from the solution tank and rinse.
- Clean the filters and screens to prevent blockages.

Imatge 6.1: posterior view of the machine, illustrating the recovery tank hose and drain points for easy emptying and cleaning.
- Brush/Pad Care:
- Remove and clean the brush or pad after each use.
- Inspect brushes for wear and replace when bristles are significantly worn.
- Pads should be replaced when their abrasive properties diminish.
- Squeegee Maintenance:
- Inspect the squeegee blades for wear or damage. Replace if necessary to ensure effective water pickup.
- Clean the squeegee assembly to remove any debris.
- Cura de la bateria:
- Recharge batteries after each use. A full charge takes approximately 7.5 hours and provides a 2.5-hour runtime.
- Store the machine with fully charged batteries to prolong battery life.
- Periodically check battery terminals for corrosion and clean if necessary.
- Neteja general: Netegeu l'exterior de la màquina amb un anunciamp tela. No utilitzeu productes químics aggressivs ni netejadors abrasius.
7. Solució De Problemes
| Problema | Causa possible | Solució |
|---|---|---|
| La màquina no arrenca | Low or discharged battery; Power switch off; Loose battery connection. | Charge batteries; Ensure power switch is ON; Check battery connections. |
| Mal rendiment de fregat | Worn brush/pad; Incorrect brush/pad for surface; Insufficient cleaning solution. | Replace brush/pad; Use correct brush/pad; Refill solution tank. |
| Water not being recovered | Worn or damaged squeegee blades; Recovery tank full; Suction hose clogged. | Replace squeegee blades; Empty recovery tank; Clear suction hose. |
| La màquina deixa marques | Dirty squeegee blades; Improper cleaning solution; Uneven squeegee pressure. | Clean squeegee blades; Use recommended cleaning solution; Adjust squeegee. |
If problems persist after attempting these solutions, please contact Dapper Supply customer support.
8. Especificacions
| Característica | Detall |
|---|---|
| Número de model | DP-WBFS1201 |
| Font d'alimentació | Battery Powered (2 x 12V Lead Acid Batteries included) |
| Voltage | 24 Volts |
| Potència del motor del raspall | 500 watts |
| Potència del motor d'aspiració | 500 watts |
| Velocitat del raspall | 200 RPM |
| Amplada del raspall | 16 polzades |
| Amplada de la escoba | 21.5 polzades |
| Capacitat del dipòsit de solució | 6.5 galons |
| Capacitat del dipòsit de recuperació | 8 galons |
| Temps d'execució | 2.5 hores (aprox.) |
| Temps de càrrega | 7.5 hores (aprox.) |
| Eficiència de neteja | 18,836 peus quadrats per hora |
| Pes de l'article | 180 lliures |
| Dimensions del producte (L x A x A) | 38 x 22 x 45 polzades |
| Material | Metall |

Image 8.1: The machine's dimensions, illustrating its compact and portable design.

Image 8.2: Key performance specifications including solution tank, recovery tank, cleaning efficiency, runtime, and brush speed.
9. Garantia i Suport
The Dapper Supply DP-WBFS1201 is backed by a one-year warranty, providing peace of mind and assurance of quality.
- Cobertura de la garantia: Consulteu la documentació de compra per conèixer els termes i condicions específics de la garantia.
- Atenció al client: For technical assistance, troubleshooting, or to inquire about replacement parts, please contact Dapper Supply customer service.
- Informació de contacte: Visit the official Dapper Supply website or refer to your product packaging for the most current contact details.





