Humanscale CPU200 CPU Holder Installation Guide

Humanscale CPU200 CPU Holder

Acabatview

Assemble and mount the CPU600 unit onto the track system by positioning and securing the brackets and mounting rails, installing the track underside of the desk, attaching the unit to the track, and covering the slot with the track cover.

Especificacions

• Títol del document: CPU600 Installation Guide
• Included items referenced in instructions: Perilla d'amplada, Bloqueig d'alçada, Suport lateral, Assemblea Superior, Base, Carrils de muntatge, Pista, Cinta de muntatge, Cargols de rosca, Portada de la pista, Clips

Quick Setup & Use

1. Assemble CPU600: Loosen the Width Knob and slide the Side Bracket outward. Loosen the Height Lock and slide the Upper Assembly to its highest position. Center the CPU on the Base.
2. Secure CPU positioning: Lower the Upper Assembly until it lightly touches the top of the CPU, then tighten the Height Lock. Push the Side Bracket inward until it fits tightly against the side of the CPU.
3. Set rail position: Center the Mounting Rails above the CPU and tighten the Width Knob securely.
4. Install track under desk: Position the track approximately 1/4 back from the front edge of the desk with folded tabs facing away from the desk edge. Use Mounting Tape to temporarily affix the Track to the underside of the desk.
5. Fix track permanently: Permanently secure the Track using the Tapping Screws.
6. Attach CPU600 to track: Align the Mounting Rails with the front edge of the Track and slide the unit onto the Track.
7. Cover the track slot: Slide the Track Cover into the Track slot behind the unit, then use the provided Clips to secure the Track Cover to the Track.

Instal·lació de la CPU

Pas 1
Loosen the Width Knob and slide the Side Bracket outward. Loosen the Height Lock and slide the Upper Assembly to its highest position. Center the CPU on the Base.

Pas 2
Push the Upper Assembly until it lightly touches the top of the CPU, then tighten the Height Lock. Push the Side Bracket inward until it fits tightly against the side of the CPU. Center the Mounting Rails above the CPU and tighten the Width Knob securely.

Instal·lació de la pista

Pas 1
Position the track approximately 1/4″ back from the front edge of the desk, ensuring the folded tabs face away from the desk edge. Use the provided Mounting Tape to temporarily affix the Track to the underside of the desk. Permanently secure the Track using the Tapping Screws.
Pas 2
Align the Mounting Rails of the assembled CPU600 unit with the front edge of the Track and slide the unit onto the Track.

Pas 3
Slide the Track Cover into the Track slot behind the unit.
Pas 4
Use the provided Clips to secure the Track Cover to the Track. Your CPU600 Track system is now fully installed. 

Instruccions d'eliminació
To safely remove the CPU600 unit from the Track system, remove the securing Clips, slide out the Track Cover, and carefully slide the CPU600 unit forward and off the Track.

Resolució de problemes

• CPU not seated securely within the assembly: Re-check that the Upper Assembly is lowered until it lightly touches the top of the CPU, and that the Height Lock is tightened. Ensure the Side Bracket is pushed inward until it fits tightly against the side of the CPU.
• Mounting rails not aligning with the track: Confirm the Mounting Rails are centered above the CPU before tightening the Width Knob, then realign the rails with the front edge of the Track before sliding the unit on.
• Track cover not fitting behind the unit: Verify the Track Cover is slid into the Track slot behind the unit and that the securing Clips are installed to hold it in place.
• Need to remove the unit safely: Remove the securing Clips, slide out the Track Cover, and carefully slide the CPU600 unit forward and off the Track.