tuya Smart Security Camera App User Manual

Smart Security Camera App
Manual d'usuari

Smart Security Camera App

TUYA CAMERA QUICK START GUIDE
Aquest manual està disponible en els idiomes següents
Tuya Smart Device 

https://smartapp.tuya.com/tuyasmart

Paràmetres bàsics

Nom del producte: càmera intel·ligent
Compressió de vídeo: H.265 High Profile
Image Enhancement: Digital Wide Dynamic 3D Noise Re ductionLocal Storage: TF card Wireless
Xifratge: WEP / WPA / WPA2
Encryption Wireless Standard: 2.4G 802.11 b/g/n
Plataforma de suport: Android/iOS
Component Description: Reset Button: Long press “reset” hole 5sec,reset success. It is recommended to insert 8-128GB high-speed TF card, otherwise it will not beagle to store, view historical video and supportlmportantfunct  ions such as firmware upgrading.

1. Instal·leu l'APP
   Download APP: scan the QR code install.
   Register and login: open the “TuyaSmart” APP to register and login according to the prompts.
2. Afegiu el mode de codi QR d'escaneig de dispositiu
   “Make sure Wi-Fi is available and connected to the Internet. “Connect the camera to the power, then system startup completed. Open “TuyaSmart” APP, press the’+’ in the upper right corner of the main screen (Figure 01); choose Security & Sensor” click “Smart Camera (Figure 02) to add camera; and then click “Next step” (Figure 03);
3. If the mobile phone is not connected to wi-fi, please click “Connect to Wi-fi” (Figure 04);it will jump to the WLAN interface an d connects Wi-Fi (Figure 05). Please note that only 2.4 GH Wi-Fi network is supported; If the phone is connected to Wi-Fi (Figure 06);
4. click “Confirm”. It will jump to the interface to prompt to scan the QR code with camera and click “Continue”(Figure.07);A QR code will prompt on your screen and you need to scan it with the Smart Camera. (the camera is about 20-30 cm away from the mobile phone lens).Then click “hear the prompt sound”(Figure. 08).’connecting”(Figure.09);

5. When the progress reaches 100%,connection completed(Figure 10), and click "Finish"; Then jump to preview interface (Figure 11)After closing the device preview interface, the interface retimes to the Appose page. At this time, the connected device will appear on the APP homepage (Figure 12). Then you can click directly to the device interface to seethe monitoring situation

without re-adding afterward

Informació per als usuaris

Nota: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and may radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. if this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and back on, the user is encouraged to attempt to correct the interference by one or more of the following measures.
-Reorienting or repositioning the receiving antenna.
-Increasing the distance between the equipment and the receiver.
-Connecting the equipment to an outlet on a circuit different from that to which the receiver is connected.
-Consulteu amb el distribuïdor o amb un tècnic de ràdio/TV amb experiència per obtenir ajuda.
Important: Changes or modifications not expressly approved by the manufacturer responsible for compliance may cause the user to lose operation.or modifications not expressly approved by the manufacturer responsible for compliance could cause the user to lose the right to operate the equipment.